Set Properties › Protect Your System State › How to Configure System State Protection

How to Configure System State Protection

By default, System State Protection is set to Off. You can enable System State Protection during scenario creation using the wizard, or you can enable it for existing scenarios using the Scenario Properties pane of the CA ARCserve RHA Manager.

For either method, you need to perform the following tasks:

• Enable the System State Protection property for the scenario
• Set the snapshot schedule, as desired.
• Enable the Store System State Protection property on one or all Replicas involved in the scenario.

Note: After System State is restored on a Replica, that machine must be rebooted so the system state can take effect. You can set the Reboot After Recovery property to On, if desired.