Add a Nimble Storage Array

You can add a Nimble storage array.

Follow these steps:

  1. From the Add a Storage Array dialog, select Nimble from the Storage Vendor drop-down option.

    2. Add a storage array for Nimble

  2. Provide the following details for the specific type of array:

    3. Array IP

    Specifies the IP address of the array. Enter the Nimble storage array management IP address.

    Data IP

    Specifies the Data access IP (Logical Interface) of the nimble storage array, where the target machines (ESXi) can access this storage array for read and write operations. If the nimble storage array supports only the FC protocol, then enter NA.

    Username

    Specifies the user name to connect to the storage array.

    Password

    Specifies the password for the user name.

    Protocol

    Specifies the protocol to connect to the array.

    Note: Only HTTPS is supported.

    Port

    Specifies the port number of the array.

    Default: 5392

  3. Click Save.

    4. The storage array is added to the Console.