The statistics reports can accept and parse a variety of report filters; however, not all filters are required for all the reports. Based on the type of report that is being generated, only the filters required and supported by that specified report will be used.
To run any advanced report, you must specify at least the report type and the path to where the generated report will be saved.
The following report types, along with the corresponding supported filters can be generated using the statistic report category:
This report provides information on what percentage of backup attempts that are successful and also shows percentage of incomplete and failed backup attempts.
This report provides information on what percentage of backup attempts that are successful on a per node basis.
This report provides information on what percentage of all restore attempts that are successful.
This report provides information about the average throughput that is being seen on the tape drives in the system. Throughput obtained from this report can be compared against the native throughput of the drive. The output of this report can be filtered to specific drives by specifying the drive serial number.
This report shows the number of errors and warnings generated for the backup job for each of the backup paths during the reporting period. This helps in determining the clients with most number of errors.
This report shows the clients with the most failed backup attempts during the reporting period.
This report shows the clients with the consecutive failed backup attempts during the reporting period.
This report shows the clients with the most number of partial backups. This reports help identify and restore critical file.
This report shows the average backup time, average backup data, and average throughput for full backups of all backup paths during the reporting period.
This report shows the status of last execution of all the backup jobs in the queue. If a job is still active, it shows the current status of the running job. This report only shows the status of the job in the queue at the time the report is generated.
This report shows the list of tapes that will move in or out of the vault on the day of reporting.
Copyright © 2015 |
|