When you select a specific job execution the following information is displayed:
In the top pane, the following information is displayed:
The time the job started.
The name of the job.
Note: This release of Arcserve Backup does not display blank job names in the Job Status Manager. If you upgraded from a previous Arcserve release, migrated the job history data, and the jobs contained blank job names, the names of the jobs display in the Job Name field in the Job Status Manager in the following format:
[<<machine name>>] <<job no>>
The last result is determined from the following criteria:
The amount of data backed up for the job.
The number of files backed up for the job.
The number of files missed during the backup.
Note: Use Arcserve Backup Agent for Open Files to backup open files to avoid missed files during a backup.
Note: If little or no data is backed up by the backup job, a value of N/A appears in the MB/Minute field.
Identifies the specific execution of the job.
Identifies the job.
Identifies the session number of the session that contains the backup data.
Identifies the subsession number of the session contains the backup data.
The amount of actual data to be stored divided by the amount of data stored after deduplication expressed as a ratio or percentage.
In the bottom pane, the following information is displayed:
The start time and end time of the selected job.
The total number of hosts the job attempted to backup.
The number of sessions that were backed up by the selected job execution.
The number of sessions migrated in a disk or tape staging job.
The tape drive or file system device used during the backup. Multiple tape drives can also be used for the same host in a single job execution if the job is a multi streaming job.
The media that was used during the backup of the host. Multiple media can also be used for the same host in a single job execution if the job is a multi streaming job.
Displays the errors and warnings that are generated during the back up of a host.
Copyright © 2016 |
|