Circumstances may arise that require you to stop and start only one or two Arcserve Backup services. Arcserve Backup lets you use the command line to stop individual services.
To stop and start the Arcserve Backup services using the command line
Substitute one of the following for [enginename]:
Arcserve Communication Foundation (Global)
CADashboardSync
Arcserve_RemotingServer
Arcserve Communication Foundation
CASMgmtSvc
CASTapeEngine
CASJobEngine
CASDbEngine
CASMessageEngine
CASDiscovery
CasUnivDomainSvr
CasSvcControlSvr
CASportmap
Note: If stop and restart the Arcserve Remote Procedure Call service (CASportmap) using the Command Line (or the Computer Management console), the service cannot communicate with its port assignments properly. This can prevent a user account with caroot equivalence from logging in to the Arcserve Backup domain. To remedy the inability to log in to the Arcserve Backup domain, run the cstop command and then run the cstart command. This enables the service to communicate properly and lets the user account with caroot equivalence log in to the Arcserve Backup domain.
"Alert Notification Server"
Note: For this service, you must provide quotation marks.
CASUniversalAgent
Note: Repeat this step to start and stop each Arcserve Backup service.
Copyright © 2016 |
|