The bab command controls the Arcserve Backup services. The bab management utility can be used to load and unload back-end services, display current status and configuration, reconfigure back-end services, and show whether or not the services are running.
The bab command works as a front-end to the Arcserve Service Controller service and requires that Arcserve Service Controller service be running for loading the back-end services.
The full set of Arcserve Backup back-end services includes five services:
Note: When a Arcserve Backup server is configured as cluster-aware, all critical Arcserve base-related services (not agent-related services) will be monitored by the applicable cluster service (MSCS or NEC CLUSTERPRO). If an Arcserve base-related service fails or needs to be shut down, the cluster service will automatically try to restart it or trigger a failover if the restart attempt fails. To run the this task, you must stop Arcserve services. However, in a cluster-aware environment, you must first manually stop the cluster service from continuing to monitor the service and attempting an automatic restart or failover. For procedures to stop HA service monitoring by the Cluster Service, see the Administration Guide.
|
Copyright © 2016
|
|