Setting Properties › Protect Your System State › How to Configure System State Protection › Configure System State Protection in the Scenario Creation Wizard

Configure System State Protection in the Scenario Creation Wizard

System State Protection can be enabled for any Arcserve RHA supported server type, from directly inside the Scenario Creation Wizard.

To enable System State Protection in the Wizard

1. From the Arcserve RHA Manager, start the scenario creation wizard using the toolbar button or the menu command: New, Scenario.
2. Complete the steps in the usual manner for the server type you selected until you reach the Scenario Properties dialog.
3. Under Replication properties, set System State Protection to On.
4. Under System State Protection, click the Value for Set Schedule to access the Schedule Setting dialog.
5. Set the schedule for taking system state snapshots.
6. Complete scenario creation steps as usual until you reach the Master and Replica Properties dialog.
7. Expand Replication properties on the Replica and set the Store System State on this Replica property to On. You may also set additional storage properties at this time. For more information, refer to the topic, Store System State Properties.
8. Save and run the scenario. System State Protection starts.