Setting Properties › Protect Your System State › How to Configure System State Protection › Configure System State Protection on the Replica

Configure System State Protection on the Replica

If you did not enable System State Protection on the Replica when creating the Scenario, you can configure the Store System State on this replica property outside the Scenario Creation Wizard using the following procedure.

Notes:

• You can enable System State Protection on multiple Replicas.
• By default System State Protection is set to off.

To configure system state protection of the Replica

1. From the Arcserve RHA Manager, select a Replica to enable its System State Protection property.
2. On the Properties panel, expand the Replication node and set the Store System State on this replica node property to On.
3. Modify the Replica storage property values as required. For more information, refer to the topic, Store System State Protection Properties.
4. Save the Scenario.