Previous Topic: Example 3: Appliance and CS are Behind a Closed FirewallNext Topic: Perform BMR from a Rewind Point

Configuring the RHA NAT Utility for Various Network Setups › Example 3: Appliance and CS are Behind a Closed Firewall › Create a Full System HA Scenario

Create a Full System HA Scenario

Before you create the Full System HA scenario, perform the following steps on the appliance.

Follow these steps:
  1. Launch the RHA NAT utility from the engine folder on the appliance.
  2. Enter the following IP addresses and port details.

    155.35.76.203, 25000

  3. Click OK to apply the configuration.
  4. Next, open the RHA Manager and click New on the standard toolbar to create the Full System scenario.
  5. Select Full System with the product type HA and AR.
  6. Enter the Master IP address (155.35.76.203) and port number (25000). This IP is the external IP address of Firewall 1 with port 25000 forwarded to Master 1 (192.168.0.112).
  7. Enter the IP address (9.181.101.240) of the virtual platform and the default port number (443).
  8. Enter the IP address (9.181.101.199) of the appliance and the port number (25000).
  9. Enter details of volume, resource pool, storage, scenario properties, and host properties similar to that of a full system scenario.
  10. Select the switchover type and run the scenario.