Perform Scenario Management Tasks › Protect Your System State › How to Configure System State Protection › Set the System State Protection Schedule

Set the System State Protection Schedule

If you did not enable set a System State Protection schedule when creating the Scenario, you can configure the System State Protection schedule property outside the Scenario Creation Wizard using the following procedure.

Note: By default System State Protection schedule is set to off.

To set the System State Protection Schedule

1. From the Arcserve RHA Manager, select a Scenario to set the System State Protection Schedule property.
2. On the Scenario Properties panel, expand the Replication node and expand the System State Protection node.
3. Click the Value column of the Set Schedule node.

   The Set Schedule dialog opens.

4. Set the day, start time, frequency, and exclude dates as needed.
5. Click OK.