Installing and Uninstalling Arcserve RHA › Managing the Engine

Managing the Engine

After the installation, the Arcserve RHA Engine is automatically managed by the operating system: it is started during the operating system boot sequence, and stopped during the operating system shutdown process. These procedures are done automatically through .rc scripts.

However, if you need to manually stop the engine and then start it again, do the following:

Linux

To start an Engine

/etc/init.d/ARCserveRHA start

To stop an Engine

/etc/init.d/ARCserveRHA stop

Solaris

To start an Engine

/etc/init.d/ARCserveRHA start

To stop an Engine

/etc/init.d/ARCserveRHA stop

AIX

To start an Engine

/opt/CA/ARCserveRHA/bin/ARCserveRHA.rc start

To stop an Engine

/opt/CA/ARCserveRHA/bin/ARCserveRHA.rc stop