Use Hardware Snapshot for VMware Agentless Backup
Follow these steps:
- Verify if the following prerequisites are met:
- Arcserve UDP supports NetApp iSCSI//FC LUNs and NetApp NFS Volume exports that are configured as Data stores. iSCSI, FC, and NFS must meet certain conditions to use the hardware snapshot.
- To create a hardware snapshot for VMware, add the storage array to the Console. For more information on adding a storage array, see Add a Storage Array.
- To use a hardware snapshot, Flexclone license is recommended for NetApp storage arrays running with data ONTAP, operating in the 7-Mode and Cluster mode.
- To support the VMware VM hardware snapshot, HP RMC must manage the HPE 3PAR storage array.
- The storage array needs to have Virtual copy license.
- Supported protocols for VMware hardware snapshot: FC and iSCSI
- To create a hardware snapshot for VMware, add the storage array to the Console. For more information on adding a storage array, see Add a Storage Array.
- Supported protocols for VMware hardware snapshot: FC and iSCSI
- To create a hardware snapshot for VMware, add the storage array to the Console. For more information on adding a storage array, see Add a Storage Array
- Considerations for Nimble Storage When CHAP Authentication is enabled
- Log on to the Console and create a plan for backup.
- Note: For more information on creating an agentless backup plan, see How to Create a Host-based Agentless Backup Plan.
- Verify that you have selected the Use hardware snapshot wherever possible option in the Advanced tab.
- Note: To run backup only from hardware snapshot (not software snapshot), Arcserve UDP provides the following registry key: FallbackToSWSnapshot =0(dword)
- You can apply this registry key for a specific node as well as all nodes.
- To apply for a specific node create the registry under HKEY_LOCAL_MACHINE\SOFTWARE\Arcserve\Unified Data Protection\Engine\AFBackupDll\(Nodeid)
- To apply for all nodes create the registry under HKEY_LOCAL_MACHINE\SOFTWARE\Arcserve\Unified Data Protection\Engine\AFBackupDll
- Save the plan and submit the backup job.
For NetApp Snapshot
Considerations for NetApp iSCSI/FC Support for VMware
Considerations for NFS Support for VMware
Note: For more information on configuring NetApp, refer the NetApp documentation or contact the NetApp Support team.
HPE 3PAR hardware snapshot:
Nimble hardware snapshot:
Note: The (Nodeid) is created only after one backup.
Important! If "AFBackupDll" sub-key is not available, then you need to manually add sub-key AFBackupDll under engine as Engine\AFBackupDll\ and then add DWORD FallbackToSWSnapshot under AFBackupDll.
The backup job runs using the hardware snapshot.