![Previous Topic: Perform BMR in Advanced Mode](574.png)
![Next Topic: BMR Reference Information](573.png)
Using Arcserve UDP Agent (Windows) › How to Perform a BMR Using a Backup › Verify that the BMR was Successful
Verify that the BMR was Successful
To verify that the BMR was successful, perform the following tasks:
- Reboot the operating system.
- Verify all systems and applications function correctly.
- Verify all network settings are properly configured.
- Verify the BIOS is configured to boot from the disk on which the boot volume was restored to.
- When the BMR is completed, be aware of the following conditions:
- The first backup that is performed after the BMR is a Verify Backup.
- When the machine has been rebooted, you may need to configure the network adapters manually if you restored to dissimilar hardware.
Note: When the machine is rebooting, a Windows Error Recovery screen may be displayed indicating that Windows did not shut down successfully. If this occurs, you can safely ignore this warning and continue to start Windows normally.
- For dynamic disks, if the status of the disk is offline, you can manually change it to online from the disk management UI (accessed by running the Diskmgmt.msc control utility).
- For dynamic disks, if the dynamic volumes are in a failed redundancy status, you can manually resynchronize the volumes from the disk management UI (accessed by running the Diskmgmt.msc control utility).
Copyright © 2015 Arcserve.
All rights reserved.
![Previous Topic: Perform BMR in Advanced Mode](574.png) ![Next Topic: BMR Reference Information](573.png)
|
|