Using Arcserve UDP Agent (Windows) › Perform a Restore › How to Restore a File/Folder for an Agentless Virtual Machine › Connect Virtual Machine and Navigate to the Destination
Connect Virtual Machine and Navigate to the Destination
Using the Restore screen of the agent, you can connect the virtual machine to the Arcserve UDP agent.
Follow these steps:
- To connect the virtual machine to the agent, use one of the options:
- From outside or inside the virtual machine, use https://<virtualmachinename>:8014.
- From inside the guest OS of <virtualmachinename>, use https://localhost:8014.
- Enter the administrator credentials of the virtual machine in the Connect pop-up screen.
- From the Tasks tab, click Restore.
- From the Restore screen, click Browse Recovery Points.
- From the Browse Recovery Points pane, click Change to specify the backup location
- Select the backup destination that was specified in the plan using one of the following options:
- If you are connecting to the Recovery Point Server, choose the Select Recovery Point Server option.
- Enter the Recovery Point Server details such as Hostname, Credentials, Port, and Protocol.
- Upon completion of successful authentication you can connect to the RPS server and the Data Store option will display a drop-down list of all available data store.
- Select the Data Store, and a list of nodes is displayed in the right panel.
- Select the node, and click OK.
- You can use the Select local disk or shared folder option only if the backup destination in the plan was provided as a network share.
The Browse recovery Points interface is displayed with selected details.
Copyright © 2015 Arcserve.
All rights reserved.
|
|