When you back up Linux Nodes, the default /tmp folder is used to store the disk snapshot file. The /tmp folder must have sufficient empty space. To change the snapshot path on Linux Nodes, you can configure a node-specific file and specify the new path.
Follow these steps:
/opt/Arcserve/d2dserver/configfiles/node
Note: If the folder is not present, create the folder.
The node folder contains the <node_name>.cfg file. Each node has its own cfg file.
target_snapshot_dir=<path>
Note: If the <node_name>.cfg file is not present, create the file.
Example: If the node name is d2dbackupnode and you want to store the snapshot under the /d2dsnapshot path, then open the following cfg file:
/opt/Arcserve/d2dserver/configfiles/node/d2dbackupnode.cfg
Add the following line:
target_snapshot_dir=/d2dsnapshot
The snapshot folder on target node is configured.
Copyright © 2016 |
|