With Configuration Options, the user can specify the transport protocol used to broadcast queries.
Enable Discovery of Arcserve Backup Products allows the Discovery Service (DS) to broadcast queries repeatedly, with a specified interval. It is not recommended that this be run at all times because it continually broadcasts queries which could increase network traffic.
Enable Network Discovery allows the DS to run a process of discovering new Windows domains and IP Subnets. By default, the DS runs this process only when the Discovery Service is restarted. You can also modify the interval, depending on how dynamic your network environment is.
Network:
Enable Discovery of Arcserve Backup Products
Enable Discovery using TCP/IP Subnet Sweep
Discovery Settings
Clean Up Discovery Table on Startup
Adapters:
Select IP address to Run Discovery
Note: New settings will take effect only after Discovery Service restarts.
|
Copyright © 2016
|
|