Settings › Manage Backup Settings › Specify Pre/Post Backup Settings

Specify Pre/Post Backup Settings

CA ARCserve D2D lets you specify the Pre/Post Backup settings.

Note: To view a video that is related to these Backup Settings, see Manage Backup Settings.

Specify the Pre/Post Backup Settings

1. From the CA ARCserve D2D home page (or CA ARCserve D2D Monitor), select Settings from the taskbar and then select the Backup Settings tab. When the Backup Settings dialog opens, select Pre/Post Backup.

   The Pre/Post Backup Settings dialog opens.

   

2. Specify your pre/post backup setting options.

   Actions

   Runs script commands for actions to take before the start of the backup, after the snapshot image is captured, and/or upon the completion of the backup. You can also trigger the script command based upon specific exit codes and select the action to be taken (run job or fail job) when that exit code is returned.

   • A "run job" action directs CA ARCserve D2D to continue to run the job if the specified exit code is returned.
   • A "fail job" action directs CA ARCserve D2D to cancel the job if the specified exit code is returned.

3. Click Save Settings.

   Your pre/post backup settings are saved.