

Arcserve RHA Troubleshooting › The Disk is Full
The Disk is Full
"CR01488" "The disk is full. Stopping replication"
Reason:
This message can refer either to the Master or to the Replica. However, in most cases it refers to lack of free disk space on the Replica, which prevents the replication from continuing.
Several common factors can cause the Replica disk to become full:
- When the size of the replicated data is bigger than the Replica disk size, the Replica disk will become full before all the replicated data is applied.
- When the Replica contains other data, it may not leave enough free space to store the replicated data.
- When VSS snapshots are created on a scheduled basis and are stored on the Replica, they may gradually occupy too much disk space.
Action:
You can do one or all of the following actions:
- Free space on the full disk for the replicated data.
- Check and compare the disk volume capacity of the Replica and the size of the replicated data, and select a Replica host with enough free disk space.
- If the system is configured to create VSS snapshots on a scheduled basis, you can either remove old snapshots or change the VSS snapshot schedule and properties.
Copyright © 2015 Arcserve.
All rights reserved.
 
|
|