Adding and Managing Destinations › How to Add a Destination › Add Arcserve Backup Servers

Add Arcserve Backup Servers

Add an Arcserve Backup Server to archive data to a tape. When you create a plan to archive data to a tape device, you can use this destination.

Follow these steps:

1. Log in to Arcserve UDP, and click the resources tab.
2. From the left pane, navigate to Destinations, and click Arcserve Backup Servers.

   The Destinations: Arcserve Backup Servers page is displayed in the center pane.

3. Click Add an Arcserve Backup Server.

   The Add an Arcserve Backup Server page is displayed.

4. Enter the following details:

   Node Name/IP Address

   Specifies the node name or the IP address of the Arcserve Backup server.

   Authentication Type

   Specifies the type of authentication used to log in to the Arcserve Backup server. The following two options are available:

   Windows Authentication

   Specifies that the Windows authentication is used to log in to the Arcserve Backup server.

   Note: The Windows user must be registered in Arcserve Backup first using Arcserve Backup User Profile Manager.

   Arcserve Backup Authentication

   Specifies that the Arcserve Backup authentication is used to log in to the Arcserve Backup server.

   Username and Password

   Specifies the user name and its password that helps you log in to the node.

   Note: Use one of the following formats for the user name: Computer name, domain name/username, or username.

   Port

   Specifies the port number that is used to connect to the Arcserve Backup server.

   Note: Arcserve UDP uses the port number to connect to both the servers, the Arcserve Backup Primary server and the Member server in the Arcserve Backup domain.

5. Click Save.

   The Arcserve Backup Server is added to the Console.

After adding the Arcserve Backup Server to the Console, you can navigate to resources, Destination, Arcserve Backup Servers and check detailed information of the tape media.