Exploring and Configuring Arcserve UDP › How to Migrate Arcserve r16.5 Recovery Points to Arcserve UDP › Replicate Arcserve r16.5 Data to the UDP Data Store

Replicate Arcserve r16.5 Data to the UDP Data Store

After creating the data store, you can replicate the Arcserve r16.5 recovery point data using RPS Jumpstart.

Follow these steps:

1. Click Actions and then click RPS Jumpstart.

   The RPS Jumpstart Wizard opens.

2. Select From a shared folder to a data store on Selected Recovery Point Server.
3. Specify the source shared folder.

   The recovery point details are displayed.

   Note: If the session is not encrypted and the target data store is unencrypted, then session password is optional. If the session is not encrypted and then target data store is encrypted, then you have to provide a session password in the Select Target Data Store page.

4. Click Next.

   The Select Target Data Store page opens. If the source data is encrypted, only the encrypted data stores are displayed in the drop-down list.

5. (Optional) Specify the session password if the session is not encrypted in Step 3.
6. Click Next.
7. Click Finish.
8. The recovery point data from Arcserve r16.5 is replicated to the Arcserve UDP data store.