Adding and Managing Source Nodes › How to Manage Nodes › Update Nodes

Update Nodes

You can update information that is related to the existing nodes. You can update the node anytime. Some of the situations when you need to update a node are as follows:

• A new product is installed on the node after the node was registered with Arcserve UDP.
• The user name or password of the node was updated after the node was registered with Arcserve UDP.

Note: If a node acts as both recovery point server and agent, and you change the credentials or protocol of that node, then update the node from the Destinations: Recovery Point Server page. The plan will automatically deploy to the agent after you update the recovery point server. If you update the node from the Nodes: All Nodes page, then the plans involving those nodes are not deployed successfully. To deploy the plan, update the node from the Destinations: Recovery Point Server page again.

Follow these steps:

1. Click the resources tab.

   The Nodes: All Nodes page is displayed.

2. Perform one of the following actions:
   • Right-click the node name.
   • Select the node name, and from the center pane click the Actions drop-down list.
   • Select the node name, and from the right pane click the Actions drop-down list.
3. Click Update.

   The Update node dialog opens.

   The following dialog is for Linux nodes:

   

4. Update the details and click OK.

   The node information is updated.