Previous Topic: Excluir grupos de nósNext Topic: Como adicionar e gerenciar um site

Adicionando e gerenciando nós de origem › Como adicionar e gerenciar grupos de nós › Find Array and Data IP of the SVM Storage Array for the Arcserve UDP Console

Find Array and Data IP of the SVM Storage Array for the Arcserve UDP Console

This section describes how to find Array and Data IP when the NetApp Storage array is running in the cDOT(clustered) mode.

Note: Only applicable for the Cluster (SVM).

Siga esses passos:

  1. Login to the NetApp system manager and connect to the cluster with valid credentials.
  2. Identify the SVM that you want to add to the Arcserve UDP console.

    Identificar a SVM que você deseja adicionar ao console do UDP

  3. Change the View to Cluster.
  4. From Cluster, Configuration, click Network, and then open Network Interfaces.

    Interfaces de rede de modo de exibição

  5. Filter the storage virtual machine by the SVM that you have identified.

    Filtrar a máquina virtual de armazenamento pela SVM que você identificou

  6. Find out which interface has:

    Localizar endereço IP

  7. Get the Management Access IP address and the Data protocol access IP address for the following, and provide them at Add Storage Array in the UDP Console:

    Note: The ESXi server must use the same Data protocol access IP address for read and write to the NetApp storage array for iSCSI or NFS.