Previous Topic: Deploy the D2D Probe to the D2D ServerNext Topic: Configure the D2D Node Status Report

Using the CA ARCserve D2D Probe for Nimsoft › How to Deploy and Use the CA ARCserve D2D Probe for Nimsoft › Monitor CA ARCserve D2D Alarms

Monitor CA ARCserve D2D Alarms

After the D2D probe is deployed on the D2D server, the probe sends all the enabled D2D alerts to the Nimsoft server as alarms. You can monitor these alarms either from the Nimsoft Infrastructure Manager or Nimsoft Unified Management Portal (UMP).

Note: If you change the CA ARCserve D2D communication protocol (HTTP or HTTPS) or you change the port number after the D2D probe is deployed, D2D alerts will not be sent until the probe is restarted.

Follow these steps to monitor D2D alarms from the Nimsoft Infrastructure Manager:

  1. Log in to the Nimsoft Infrastructure Manager as an Administrator.

    The Infrastructure Manager is displayed and all the Nimsoft alarms are listed in the Dock pane.

  2. Click the Filter icon.

    The Filter dialog opens.

  3. Enter D2D to display the CA ARCserve D2D alarms.

    The CA ARCserve D2D alarms are listed in the Dock pane.

Follow these steps to monitor D2D alarms from the Nimsoft Unified Management Portal (UMP):

  1. Log in to the Nimsoft Unified Management Portal as an Administrator.

    Note: To log in to the Nimsoft UMP, enter the following URL address (where <IP address> is the IP address of the machine that has UMP installed on it).

    http://<IP address>/web/guest/home

    The Nimsoft UMP interface is displayed.

  2. Click the Alarms tab.

    All alarms are displayed.

  3. Enter D2D in the filter text box to view only CA ARCserve D2D alarms.

    The listing is filtered to only display the CA ARCserve D2D alarms.